How to Install EZ Door Pre-Fab Fireplace Doors

You’ve measured your pre-fab firebox and ordered the EZ Door Fireplace Door just in time for the chilly fall weather.  When your doors arrive, you’re ready to install them on your fireplace.

With just a few tools handy, you’re ready to get started. Here are some simple instructions for the installation of your doors:

You’ll need these tools:

-Electric Drill

-5/32” Diameter Drill Bit

-#2 Phillips Screwdriver

The hardware included:

-4 installation angle brackets already attached to the frame

-4 self-tapping sheet metal screws, ¾ length

You should find these items in your package:

-Frame

-2 glass doors

-Hardware installation screws and brackets

-Instructions

Follow these simple instructions:

-Position the frame (if you have a red dot on your frame, that is the bottom) in the firebox and center it.

-Slide the brackets on the backside of the frame and position them against your firebox.  Tighten the bracket.  Mark the fireplace at each hole in the 4 angle brackets.

-Remove the frame and drill the 4 holes you marked with a 5/32” drill bit.

-Re-position the frame back into the fireplace and secure the frame using the sheet metal screws using a #2 Phillips screwdriver for each angle bracket making sure you do not over tighten.  The enclosure may be centered by loosening one side and tightening the other.

Attaching the Doors

-With the handles at the top, fold door together and locate the bottom door pivot pin.

-With the panel door at a 45 degree angle, place door pivot pin into the  frame bottom receiving hole clip.  Rotate the door to the vertical position aligning the top pin with the top receiving hole clip.

-Press down on the door and slide the door until the top pin slides into the top receiving hole clip.

-Repeat step 1 for remaining door.

Adjusting Door Position in Frame

If door adjustment is necessary, partially open the doors and reach around the back of the door and loosen the top and bottom receiving hole clips.  Slide clips to the desired position and re-tighten the screws.

(REMEMBER:  The glass doors MUST remain fully open with the screens drawn closed when the fire is burning.)

Be sure to tell your friends and family about Brick-Anew EZ Doors.  Remember that EZ Doors can be made to fit almost any pre-fab/zero-clearance fireplace including Superior, Majestic, Martin, Temco, Heatilator, or Lennox brands.  We hope you enjoy your new EZ fireplace doors!